Gas Dryer

[pie]

i have a GE gas dryer and can't get the flame to come on or ingnite
I removed the ignitor and conducted a test on it they recomend that the ohms reading be between 50-600 and my reading is 64.5 buit the ignitor was not glowing or sparking if its not the ignitor wath else can it be

[sivam2]

I had the same problem. It turned out to be a fuse that blew when I dried a large quilt. Don't dry large quilts, etc. as they fill up the drum and the the fuse blows before it gets too hot. Then the pilot light goes out and you can't light it. Cost $10 for the part and $75 for the repairman.


[QUOTE=pie]i have a GE gas dryer and can't get the flame to come on or ingnite
I removed the ignitor and conducted a test on it they recomend that the ohms reading be between 50-600 and my reading is 64.5 buit the ignitor was not glowing or sparking if its not the ignitor wath else can it be[/QUOTE]

[jrp65]

[QUOTE=pie]i have a GE gas dryer and can't get the flame to come on or ingnite
I removed the ignitor and conducted a test on it they recomend that the ohms reading be between 50-600 and my reading is 64.5 buit the ignitor was not glowing or sparking if its not the ignitor wath else can it be[/QUOTE]
I have the same problem and when i test the radiant sensor there is no ohm reading, so i'm guessin' that's what it is.